***** ALERT - Nominations for your new ClubCJ Committee can be made here *****

SST Questions

Servicing, Oil Changes, Fluids & Much More.

Moderators: Moderators, Senior Moderators

User avatar
RacerX
Lancer Newbie
Lancer Newbie
Posts: 21
Joined: Tue May 19, 2015 2:11 pm
Location: Melbourne

SST Questions

Postby RacerX » Fri Jun 19, 2015 11:38 am

Hey guys,
So im test driving a preowned MY11 Ralliart with 29000km on it tommroow. The car looks ot be quite clean, and service are all completed and well taken care of.
What should i be looking for in the test drive, any particular things that could lead to further problems later on.
Particularly in relation to the SST, how do i check the clutches are good, fludis good so on...

Help is apprectaited thanks guys.

User avatar
Lancer1993
Genius
Genius
Posts: 5342
Joined: Sat Dec 06, 2014 12:46 pm
Location: Caloundra
Contact:

Postby Lancer1993 » Fri Jun 19, 2015 12:05 pm

Best advice it to take a friend, preferably someone with some mechanical knowledge. If the car is private then do all the usual tests and ask if you can get it checked by a mechanic, if they don't agree walk away.
Image
My rides CJ VRX - CC coupe

User avatar
bunnishiwa
Lancer Legend
Lancer Legend
Posts: 1284
Joined: Thu Dec 24, 2009 4:22 pm
Location: Rye, Melbourne

Postby bunnishiwa » Fri Jun 19, 2015 12:44 pm

Re the SST - Smooth changes up through the gears in normal and sport modes (going into a freeway or 100kph rds should give you enough room to check). Switch to manual if you are comfortable and do the same using paddles and the gearstick, again looking for smooth quick changes with no surge in rpm as the gear engages. Check behavior at low speeds in normal auto mode.

At 29k the SST would not have been serviced (45k on later models). Worth getting a mech to check underneath for leaks (trans oil will be present on the tray underneath if there is one) but pretty unlikely
Last edited by bunnishiwa on Fri Jun 19, 2015 6:05 pm, edited 1 time in total.
- Self tuned - work in progress - tune revision #16_03
- GS 3 port controlled wooooot :)
- Lowered on Kings
- Black Evo X FMIC/ Evo IX BOV/ Depo HFC/ UR UICP
- Awesome self installed Alpine/JL Audio sound system
- Whiteline Rear Swaybar



Noli Timere Messorem

User avatar
sleeper
Alumni
Alumni
Posts: 8259
Joined: Fri Apr 23, 2010 10:14 am
Location: brisbane
Contact:

Postby sleeper » Fri Jun 19, 2015 1:40 pm

and check for a rattling sound from the clutches and shudders on hill starts, but that model should be fine for that :)
210 KWATW 400nm RALLIART Virtual Dyno 1/1
http://goo.gl/GrUosm


Image

himynameisdaniel
Lancer Evolution
Lancer Evolution
Posts: 824
Joined: Mon Feb 14, 2011 3:58 pm
Location: Adelaide

Postby himynameisdaniel » Fri Jun 19, 2015 3:52 pm

should you decide to purchase this vehicle.
would be wise to also factor in the cost of replacing the fluid and filters after taking ownership.

that would be your next biggest item as the remainder of the service is pretty cheap.

there are threads on here that give rough costs and also alternatives to using mitsubishi DiaQueen SST fluid.

User avatar
sleeper
Alumni
Alumni
Posts: 8259
Joined: Fri Apr 23, 2010 10:14 am
Location: brisbane
Contact:

Postby sleeper » Fri Jun 19, 2015 5:21 pm

29.000 k`s, if its at the right price buy it, u wont regret buying a RA, so easy to get so much more power out of her :)
210 KWATW 400nm RALLIART Virtual Dyno 1/1

http://goo.gl/GrUosm





Image

User avatar
bunnishiwa
Lancer Legend
Lancer Legend
Posts: 1284
Joined: Thu Dec 24, 2009 4:22 pm
Location: Rye, Melbourne

Postby bunnishiwa » Fri Jun 19, 2015 6:07 pm

Costs of the SST change are ok it you do it yourself (not much more complicated than a standard oil change). Filter for $45 and Ford branded Diaqueen (same as Mits use) is only $38/ltr (need 6.75 ltrs roughly)
- Self tuned - work in progress - tune revision #16_03

- GS 3 port controlled wooooot :)

- Lowered on Kings

- Black Evo X FMIC/ Evo IX BOV/ Depo HFC/ UR UICP

- Awesome self installed Alpine/JL Audio sound system

- Whiteline Rear Swaybar







Noli Timere Messorem

User avatar
sleeper
Alumni
Alumni
Posts: 8259
Joined: Fri Apr 23, 2010 10:14 am
Location: brisbane
Contact:

Postby sleeper » Fri Jun 19, 2015 6:09 pm

at 29000k he doesnt need a change yet, 45/50k ok if your not tracking it :)
210 KWATW 400nm RALLIART Virtual Dyno 1/1

http://goo.gl/GrUosm





Image


Return to “Maintenance”

Who is online

Users browsing this forum: No registered users and 49 guests