***** ALERT - Nominations for your new ClubCJ Committee can be made here *****

Silver Dash Trim Wrapped With Carbon Fibre Wrap

Lancer Interior Modifications.

Moderators: Moderators, Senior Moderators

Sickbunny
Lancer VRX/GTS
Lancer VRX/GTS
Posts: 391
Joined: Sun Oct 04, 2009 11:29 am

Postby Sickbunny » Tue Feb 09, 2010 6:35 pm

ive got just over half a sheet left which is plenty to do all the silver trims in the car.

Say $25 including postage to you?

User avatar
ash06
Lancer VRX/GTS
Lancer VRX/GTS
Posts: 396
Joined: Sun Dec 28, 2008 3:47 pm
Location: Sydney, NSW, Australia

Postby ash06 » Tue Feb 09, 2010 7:35 pm

$25 seems reasonable as Adrian quoted USD$50 for the full piece

i'll PM you to discuss this further
:)

thanks sickbuny

User avatar
Blakey
Lancer MASTER
Lancer MASTER
Posts: 2282
Joined: Wed Sep 16, 2009 7:53 pm
Location: Brisbane

Postby Blakey » Tue Feb 09, 2010 8:30 pm

at the guy that said if you have to take the items off to wrap them, you do have to take them off as its not a vinyl so you have to wrap it under the inside to hide the edges. unless of course, you can make the edges really neat, i have the neffywrap, just the same size adrian said. i got it when the dollar was high i think it was like $0.95 when i bought, cost me about $39-45 dont remember completely but it was quite cheap.
IF YOUR NOT LIVING ON THE EDGE YOUR TAKING UP TOO MUCH ROOM

Sickbunny
Lancer VRX/GTS
Lancer VRX/GTS
Posts: 391
Joined: Sun Oct 04, 2009 11:29 am

Postby Sickbunny » Tue Feb 09, 2010 8:44 pm

yeah mine cost i think it was $65-70AUD to get over here inc postage.

the pieces are easy enough to remove and because it is fairly thin they go back on without any problems.

User avatar
NetGX
Lancer Newbie
Lancer Newbie
Posts: 25
Joined: Sat Aug 01, 2009 10:21 pm
Location: Newcastle, Australia

Postby NetGX » Thu Mar 04, 2010 10:09 am

I like this mod, it might be a nice alternative to cover the scratches my silver trim pieces have collected in such a short time

User avatar
Lancer1993
Genius
Genius
Posts: 5342
Joined: Sat Dec 06, 2014 12:46 pm
Location: Caloundra
Contact:

Postby Lancer1993 » Thu May 14, 2015 8:24 am

I know this thread is a few years old but just wondering how do you take off the bit of trim on the right of the steering?

I've taken off the other matching bit that runs most of the width of the dash but don't know where to start on the right hand side bit.
Image
My rides CJ VRX - CC coupe

User avatar
sarusa
Lancer Legend
Lancer Legend
Posts: 1287
Joined: Fri Sep 04, 2015 3:22 pm
Location: melbourne

Postby sarusa » Tue Nov 03, 2015 1:13 pm

Wondering weather to wrap or paint or get them chromed!!! :roll:


Return to “Interior”

Who is online

Users browsing this forum: No registered users and 22 guests