Getting Closer :D - Opinions so far?

[Ronan.Butler11]

Exhaust - Check
Rims - Check
Plate Lights - Check


Im personally in love with it, yet if any has suggestions i should add to the 'to do' list i'm open to suggestions.

[lancerdarryl]

Wheels set it off quite well.

[Nate N]

Looking good mate. Just need an RA rear bar now to complete it!

[Ronan.Butler11]

was looking at one,
not sure if the exhaust will fit on the RA slot. looks like the RA has the exhausts closer together than mine
Plus i reckon it looks good stock, once i get the bumper repaired it will look better hahaha

[Nate N]

Maybe not, the XForce tips do seem further outboard. That said, a rear bumper with appropriate cut-outs would definitely make the dual exhaust stand out.

[Ronan.Butler11]

yeah, it was the original plan. the current bumper doesn't show the cut out for the stock exhaust much, so leaving it as is looks pretty good

[buchani]

coil overs

[Dannn]

Merlin tune.

How much was your cat back? Did you git it yourself or by them?

What have you done inside?

Do you have a full size spare? Thought about a custom boot floor? I made one with the mitsi badge cut through with led strips under. Looks mint!

[Mystique]

Coilovers would finish it nicely with a RA bar

RA bars on hatchbacks are so pretty! <3

[Ronan.Butler11]

Merlin tune.

How much was your cat back? Did you git it yourself or by them?

What have you done inside?

Do you have a full size spare? Thought about a custom boot floor? I made one with the mitsi badge cut through with led strips under. Looks mint!

Was a 2.5" axle back for $450 from X Force, put in myself

Inside - led dome lights, hoping to get dash etc done blue or a frost white. Looking for an asx cluster to put in

Was looking at getting a half decent tire to chuck on a stock rims and have a full size spare, havnt got around to it.

Was looking to get a mitsu badge that i could stitch in or something, rather than get a whole new liner. Do you have a contact for who did yours and what specifically it was?

Thanks mate

[Ronan.Butler11]

Coilovers would finish it nicely with a RA bar

RA bars on hatchbacks are so pretty! <3

Kicking myself over that, my exhausts are too wide for the RA bumper, would have to get them adjusted, maybe a later project

[Dannn]

I literally printed the mitsi logo (full A4 size) and stenciled it onto ply and cut with jigsaw. Bought some auto carpet felt and wrapped it, got a piece of perspex 30x30 and screwed it on, led stripped it and wired it to the boot light so when you open the boot it turns on.

[Ronan.Butler11]

Does it stick out much? thinkings of using 3mm ply and a blue mitsi logo
If you have a picture could you post it? want to know if im doing it right hahaha

[Dannn]

http://m.imgur.com/a/dVKUR

I built a 3 piece raised boot. Middle part with the logo obviously.

[Ronan.Butler11]

Looks sick, might have a look into it. i get free off cuts of timber from work, might grab some ply and have a go. The led looks good as well. is there a specific carpet you need to match the rest of the boot area?