$30 centre lip DIY

[XTPN]

Bought those universal ez-lip/rhino lip off eBay and cut it to fit between the VRX pods. Used a drill to make some holes and mounted it with zip ties. I actually like the look of the zip ties(gives it that mean look), however I am not sure how long they'll last in the sun. Might give screws a try next time. Thoughts?

[Lancer1993]

Looks good, would love to try it. Can you post the eBay link?

Guess you'll know if it's not worked when you feel it going under the car one day.

[XTPN]

Sure. Comes in a 2.35m roll, so should be more than enough.

http://www.ebay.com.au/itm/331111278755 ... EBIDX%3AIT

[Lancer1993]

That long you can make a few and have them on stand by, just in case LOL

Got any photos on just how you did the work?

Thanks for the link.

[Zaphod]

neat job!

[XTPN]

Thanks!

Not much except for this one:



Pretty much just cut the lip to shape. Mark 9 evenly space holes on the lip(about 10cm's apart). Pierce holes with a knife and thread a zip tie through each one. Position lip against car and drill a small hole(just enough to fit zip tie) through the 9 holes you previously made, and into the body of the car. Thread the zip tie in and over the grill.

Hope that helps! Can take more pictures tomorrow if needed.

[Lancer1993]

Thanks, will put this to the top on my mods list after we get back from the trip.

[luke_1993]

That looks so nice man great work

[L4DYam3nd]

Use UV treated cable ties and you should be alright