***** ALERT - Nominations for your new ClubCJ Committee can be made here *****

Manual Gear Box Oil

Servicing, Oil Changes, Fluids & Much More.

Moderators: Moderators, Senior Moderators

Ricksville
Lancer ES/EX
Lancer ES/EX
Posts: 110
Joined: Fri Oct 29, 2010 6:23 pm
Location: Sydney, Australia

Manual Gear Box Oil

Postby Ricksville » Tue May 27, 2014 5:33 pm

I've got a 2010 VRX Manual, Looking at doing an oil change. Thought I might grab some synthetic. Just wondering what other people are using??

scott_drake
Lancer VRX/GTS
Lancer VRX/GTS
Posts: 453
Joined: Thu Sep 30, 2010 1:46 pm
Location: world wide

Postby scott_drake » Tue May 27, 2014 5:57 pm

put in Amsoil 75-90w API GL-4 Manual Transmission Lube, about $28-$32 per bottle, get yourself 7 bottles, 3-3.5 to properly flush the old oil (fill drive and drain and refull) out and have a clean inside, then refill with about 3-3.5bottles,t, and get 2 new crush washers and 1 fill pump bottle....U will feel the difference in shifting, it will be silky smooth shifts,

User avatar
Kal777
Lancer VRX/GTS
Lancer VRX/GTS
Posts: 404
Joined: Mon May 21, 2012 9:48 pm
Location: Adelaide

Postby Kal777 » Tue May 27, 2014 6:41 pm

The oil should only be filled to the point where it comes out the oil fill plug on the transmition. Believe the trans on the vrx is the same as the 4b11's so it holds 2.5l.

Im using Penrite Progear 75-85, it is a fully synthetic and is miles better than the stock mineral oil used in the gear box, not as clunky and shifts through the gears a lot easier when cold. Also fixed the 1st to reverse gear issue that happens every so often
Image
Injen Cold Air Intake/K&N Invert Pod/BC BR Coilovers/Whiteline Strut Brace/DrIft Blade seats/Penrite HPR5/Penrite ProGear/PBR Gold Dot

Ricksville
Lancer ES/EX
Lancer ES/EX
Posts: 110
Joined: Fri Oct 29, 2010 6:23 pm
Location: Sydney, Australia

Postby Ricksville » Tue May 27, 2014 8:36 pm

Anyone using Nulon or Castrol??

scott_drake
Lancer VRX/GTS
Lancer VRX/GTS
Posts: 453
Joined: Thu Sep 30, 2010 1:46 pm
Location: world wide

Postby scott_drake » Wed May 28, 2014 7:00 pm

Ricksville wrote:Anyone using Nulon or Castrol??


the money u pay for nulon full syntheic u might aswell go AMSOIL and get a overall BETTER oil

castrol is same as OEM, i dont rate catstrol fluids at all

User avatar
denzza
Lancer Legend
Lancer Legend
Posts: 1266
Joined: Sun Jul 15, 2012 11:27 pm
Location: Melbourne

Postby denzza » Wed May 28, 2014 7:34 pm

What about Motul 300 ?
AUSTRALIA'S FIRST 4B11T ENGINE SWAP ON E85
FULL EVO X TURBO SETUP
APEXI ARC DESIGN INTAKE | RA BRAKE SETUP | APEXI N1 EVO -R 3" CAT BACK | UR CAT |
TUNED BY BEEBLE | EXEDY H/D CLUTCH
BC RACING BR COILOVERS
Image

scott_drake
Lancer VRX/GTS
Lancer VRX/GTS
Posts: 453
Joined: Thu Sep 30, 2010 1:46 pm
Location: world wide

Postby scott_drake » Thu May 29, 2014 5:37 pm

denzza wrote:What about Motul 300 ?


motul is gl5.....and for the money u pay motul, amsoil is a better oil overall

User avatar
denzza
Lancer Legend
Lancer Legend
Posts: 1266
Joined: Sun Jul 15, 2012 11:27 pm
Location: Melbourne

Postby denzza » Thu May 29, 2014 7:11 pm

where do you buy Amsoil ?
AUSTRALIA'S FIRST 4B11T ENGINE SWAP ON E85

FULL EVO X TURBO SETUP

APEXI ARC DESIGN INTAKE | RA BRAKE SETUP | APEXI N1 EVO -R 3" CAT BACK | UR CAT |

TUNED BY BEEBLE | EXEDY H/D CLUTCH

BC RACING BR COILOVERS

Image

Ricksville
Lancer ES/EX
Lancer ES/EX
Posts: 110
Joined: Fri Oct 29, 2010 6:23 pm
Location: Sydney, Australia

Postby Ricksville » Thu Jun 19, 2014 12:02 pm

I ended up ordering redline MT-85 GL-4, Hopefully its a big improvement over the standard Oil. I'm also having my injectors sent away and cleaned and giving the Throttle body a good clean.

User avatar
denzza
Lancer Legend
Lancer Legend
Posts: 1266
Joined: Sun Jul 15, 2012 11:27 pm
Location: Melbourne

Postby denzza » Thu Jun 19, 2014 6:31 pm

Yeah i ended up going with Castrol VMX 80
AUSTRALIA'S FIRST 4B11T ENGINE SWAP ON E85

FULL EVO X TURBO SETUP

APEXI ARC DESIGN INTAKE | RA BRAKE SETUP | APEXI N1 EVO -R 3" CAT BACK | UR CAT |

TUNED BY BEEBLE | EXEDY H/D CLUTCH

BC RACING BR COILOVERS

Image

Ricksville
Lancer ES/EX
Lancer ES/EX
Posts: 110
Joined: Fri Oct 29, 2010 6:23 pm
Location: Sydney, Australia

Postby Ricksville » Mon Jun 23, 2014 11:04 am

Finally got off my arse and changed it. Big improvement over the original oil. No more cold shift issues and shifts a lot easier when warm

User avatar
lantourismo
Lancer Legend
Lancer Legend
Posts: 1248
Joined: Sat Apr 13, 2013 8:32 pm
Location: Perth, Australia

Postby lantourismo » Mon Jun 23, 2014 7:50 pm

Curious is it fairly straightforward to do the oil change for the manual transmission?

User avatar
lantourismo
Lancer Legend
Lancer Legend
Posts: 1248
Joined: Sat Apr 13, 2013 8:32 pm
Location: Perth, Australia

Postby lantourismo » Mon Jun 23, 2014 9:59 pm


Ashchop
Lancer Newbie
Lancer Newbie
Posts: 48
Joined: Sun Feb 16, 2014 8:27 pm
Location: Australia

Postby Ashchop » Tue Jul 01, 2014 6:13 pm

Yeah i was grinding gears from 1st - 2nd and 2nd - 3rd and presumed it was my sync rows. But i changed my tranny oil tonight at work using the castrol vmx 75-85W and on the way home the gears were going in smoothlyy :)
2010 Lancer VRX 👌

Tarnveeranand
Lancer Learner
Lancer Learner
Posts: 1
Joined: Mon Feb 13, 2017 11:36 am

Re: Manual Gear Box Oil

Postby Tarnveeranand » Mon Feb 13, 2017 11:52 am

Hi there,

I'm driving a Mitsubishi Lancer CJ 2010 with manual transmission. It's second and third gears were hard to shift, sometimes just couldn't shift to third so had to slow down and shift to second or even first sometimes.

I saw this post that simply changing the transmission oil has solved so many problems for some people. Therefore, I changed the transmission oil and used Castrol 75-85.

It solved my problem for around two weeks, I was very happy suddenly it started again!

Now second to third gear shift is smooth but fourth to third is very hard, most of the times I can't shift, so I have to slow down to shift to second.

Could you please share your experiences to help me?
I will be grateful to you!
Thanks to all!!


Return to “Maintenance”

Who is online

Users browsing this forum: No registered users and 29 guests