Hi all, two quick questions;
I'm looking to do some wrapping on the interior silver ES trim, and just was wondering;
1. Where's the best place/website to buy vinyl wrap?
2. Should I DIY or get professionally done?
Thanks
***** ALERT - Nominations for your new ClubCJ Committee can be made here *****
Vinyl Wrap
Moderators: Moderators, Senior Moderators
- shadow-vex
- Lancer Evolution
- Posts: 873
- Joined: Thu Jun 27, 2013 6:29 pm
- Location: camden
- shadow-vex
- Lancer Evolution
- Posts: 873
- Joined: Thu Jun 27, 2013 6:29 pm
- Location: camden
I tried to wrap my bonnet on monday. didnt turn out so well, had to abandon the idea.
wrap it self is quite cheap20 bux gets you a decent size sheet. but if your going to get some one to do it for you, the cheapest i found to wrap my bonnet was $250...
there are some little trick to it if your gona do it your self, but still takes lots of time.
wrap it self is quite cheap20 bux gets you a decent size sheet. but if your going to get some one to do it for you, the cheapest i found to wrap my bonnet was $250...
there are some little trick to it if your gona do it your self, but still takes lots of time.
RallyNut wrote:I tried to wrap my bonnet on monday. didnt turn out so well, had to abandon the idea. wrap it self is quite cheap20 bux gets you a decent size sheet. but if your going to get some one to do it for you, the cheapest i found to wrap my bonnet was $250... there are some little trick to it if your gona do it your self, but still takes lots of time.
Probably should be alright because it's only interior.
wrapping is very easy actually, a bonnet is simple minus the water sprays because it is a flat surface
the secret to wrapping is use high end wrap and its a breeze
brands like avery, 3M, and hexis are the way to go
take out the silver stuff (very easy), apply the vinyl and then heat it up
after its flush, then cut out the access and place everything back
for you first time it should take about 1-2 hours
the secret to wrapping is use high end wrap and its a breeze
brands like avery, 3M, and hexis are the way to go
take out the silver stuff (very easy), apply the vinyl and then heat it up
after its flush, then cut out the access and place everything back
for you first time it should take about 1-2 hours
My Build Thread : http://clubcj.net/viewtopic.php?t=14731
ROTM Winner OCTOBER 2015 (Nominated for favourite CJ)
-Australia's first airbagged CJ-
ROTM Winner OCTOBER 2015 (Nominated for favourite CJ)
-Australia's first airbagged CJ-
Who is online
Users browsing this forum: No registered users and 30 guests