Help with underglow lighting - quick questions ASAP response

[jmunro1]

from memory i ran my 0 gauge wire through my firewall behind the master cylinder for the brakes there was a grommet there but dont hold me to that

[rokpapaziz]

I also run wires into the cabin from there ^^ but not everyone can access that one.

Right in behind the each of the strut towers there's grommets.

OR probably most suitable for you is in the front wheel arches where the front part of the side skirts end. There's a grommet there that you can push through and then in to the cabin under the plastic panels about where the boot and fuel door levers are on each side.

Hope that makes sense

[Speedie]

Look behind the internal wheel guards there is grommets into the chassis rail. Will come out into the cabin by your kick panels.

[Neo]

not sure if this is helpful at all.. but the grommet thru the firewall is hard to find, maybe this pic i took will help

[Kyrus]

for anything under glow lighting related question there can only be one answer:

Take those out and bin them, its not 2001 anymore

[Kyrus]

for anything under glow lighting related question there can only be one answer:

Take those out and bin them, its not 2001 anymore

[Damir]

each to their own
i bloody love underglows for their uniqueness
dont see them on cars and they look fat on cj's

[Damir]

its easy, ill take photos of mine if you need a little guide on where to mount and stuff like that
just make sure you ground really good and protect your soldering with heat shrink or electric tape
use an existing 12v from your car and that should have a fuse too