What did you do on your car today?

SAM-24A · Postby **SAM-24A** » Tue Dec 06, 2011 5:47 pm

CopyCat .......

Na just kidding Ryan ....
If you really want the "R" then maybe you should get a Red R Badge from Ebay.

That's what I considered before I decided on my Signature Decals.

..

These are the Templates I made for the Label Guy.

..

Regards:Sam .... :wink:

bd-850 · Postby **bd-850** » Tue Dec 06, 2011 6:05 pm

Hoges wrote:nah will offset my colour them. I may take it off later, I dunno, see if it grows on me

im sure the sticker could be made in white

goatio · Postby **goatio** » Wed Dec 07, 2011 9:32 am

reversed into an outback learner coming outa my drivway.
raining ,2 parked 4wd's blocking the veiw ,not a hope .
looks like the smash repairs next door might trade repairs 4 xmas lunch.
the weird news is the 4wd's belong 2 the smash repairs.......

goatio · Postby **goatio** » Wed Dec 07, 2011 9:43 am

i ain't too good with the pics , i had to go and find my tow hook cover , & the hole it fits into is a bit beaten up, but its only the bumper that scratched & compressed/slightly cracked.
next door will have it looking better than when i've owned it in no time.
the subi had minimal dammage bottom back skirt a bit scratched , the owner seemed to be good for off the books repairs .
its not good , but it ain't real bad. :/

lena91 · Postby **lena91** » Fri Dec 09, 2011 3:33 pm

Put my ClubCJ decals on and got rid of the glue residue from the debadging the other day

The X · Postby **The X** » Fri Dec 09, 2011 4:03 pm

jerryme · Postby **jerryme** » Fri Dec 09, 2011 5:47 pm

My coilovers were making noise.

Found out my sway bar connects to the coilovers are rooted.

Anyone know the thread size?

Gleno · Postby **Gleno** » Sun Dec 11, 2011 2:43 pm

Finally got around to installing the lower chrome grille surround. Firstly you have to snap off the clips on the top part of the grille as the NON aspire lancers dont have the holes in the bumper for the clips to go into. Note in the 2nd picture the clip im refering to at the top of the picture.By cutting off the clips it will make the top part of the grille sit flush with the middle bumper.

Firstly i had to drill a hole on the right hand side where the solid part of the honeycombe grille is

Then drop the plastic cover

Screw from the inside of the grille,theres about 6 lugs that go thru the lower mesh grille

All done with some double sided tape on the top part of the grille and decided to put my chrome upper grill to match

Thankyou to SAM-24A for guiding me though this installation,as i have a steep driveway, there was no need to jack the car up and managed to squeeze in underneath.

SAM-24A · Postby **SAM-24A** » Sun Dec 11, 2011 3:01 pm

No Probs Glen ......

Dire · Postby **Dire** » Sun Dec 11, 2011 3:02 pm

Yay some hints for when mine gets here!

What did you do on your car today?

Who is online