*CLOSED* TWM Short Shifter GB via 9glancers

LZY_EYE · Postby **LZY_EYE** » Mon Apr 11, 2011 4:41 pm

From comparing Chris' new shorter shaft with the original one, the threads were the same. I had no problem with putting his leather knob on his new short shaft....

AUSSIECJ · Postby **AUSSIECJ** » Mon Apr 11, 2011 6:35 pm

hey the short shifter feels awesome. it wasnt to hard to install. but getting those push clips off were a pain in the ass

Kimmy · Postby **Kimmy** » Mon Apr 11, 2011 6:43 pm

Looks good

SAM-24A · Postby **SAM-24A** » Mon Apr 11, 2011 7:52 pm

OK, Just "WTF" is going on around here.

bd-850 said: nice knob

Hoges replied: gonna see if it fits on

bd-850 thought: I should see how my knob fits on the end of my shaft

LZY_EYE reckons: He had no problem with putting Chris's knob on his shaft....

Hoges : just couldn't wait to change his Knob, for the time being. :roll:

AUSSIECJ mentioned: It feels awesome. it wasn't to hard, but the push off was a pain in the ass. :shock:

and finally

Kimmy, had to mention: "Looks Good" *eek*

Sam

Mitch · Postby **Mitch** » Mon Apr 11, 2011 7:53 pm

sam sam sam funny man mate good on ya stll waiting on my shortshifter

LZY_EYE · Postby **LZY_EYE** » Mon Apr 11, 2011 7:56 pm

LOL Sam... are you disappointed you were not invited to participate??

Ryan - I used a small flat blade to start prying them off, once there was a large enough gap, I then used a big flat blade and twisted it off.

They will not be reusable.

When putting the new ones on, I found using an old socket over the clip, and tapping the socket allowed the clip to be installed evenly without damaging it.

I also didn't cut the carpet like they say you need to do. It is a little tricky, but can get away without cutting.

SAM-24A · Postby **SAM-24A** » Mon Apr 11, 2011 7:57 pm

Oh God, not you to Mitch, leave your knob alone.

LZY_EYE · Postby **LZY_EYE** » Mon Apr 11, 2011 7:59 pm

If I wasn't at work I would give you a hand.

Mitch · Postby **Mitch** » Mon Apr 11, 2011 8:01 pm

SAM-24A wrote:Oh God, not you to Mitch, leave your knob alone.

lol mate just got the shortshifter only not the knob lol

SAM-24A · Postby **SAM-24A** » Mon Apr 11, 2011 8:02 pm

Q: What do you call 4 g[s]a[/s]uys in a Panel Van with Big Tyres.

A: 4 on the Floor and Fats all round.

SAM-24A · Postby **SAM-24A** » Mon Apr 11, 2011 8:08 pm

LZY_EYE wrote:LOL Sam... are you disappointed you were not invited to participate??

What, at giving Ryan a Hand !!
Careful, Ryans GF might not approve :roll:

Although he might. :shock:

No Thanks Shane, I enjoy playing with my Floppy Flappy Paddles :lol:

Sam

CLOSED TWM Short Shifter GB via 9glancers

Who is online