***** ALERT - Nominations for your new ClubCJ Committee can be made here *****
What did you do on your car today?
Moderators: Moderators, Senior Moderators
- hansmitchel
- Lancer VRX/GTS
- Posts: 332
- Joined: Tue Dec 15, 2009 3:02 pm
- Location: Melbourne, Australia
Pivot boost gauge installed
Boost Gauge was finally installed on Friday.
[/img]
[/img]
Re: Gate Opener
chris851 wrote:
Nice Ejecter button
- DORA_ANNE
- Lancer MASTER
- Posts: 2253
- Joined: Fri Jan 01, 2010 8:07 pm
- Location: Northern Rivers NSW AUSTRALIA
Nick They Had 2 Size's ..One I Got u have to cut to Size in which Just at the left and right sides it's just a couple of inch's a bit too short But It's not much to worry about as with the Old Felt under neath the rubber liner It looks ok ..Then The other one was an actually fitted one But I didn't have my boot Measurements with me so I don't really know if it would of fitted the CJ'S ...So It might be best to take your Measurements with you and The fitted one might be the better one ..But Then Again The Fitted one was just hard plastic , I Think the Rubber ones are Better myself ..Less Slipping ...
Angels Are Sometimes Disguised As Friends
Who is online
Users browsing this forum: No registered users and 100 guests