Help?

[jm]

Hello everyone, been a while since I posted anything here so here goes....

I have the "carbon fibre" stick on decals for the door pillars. Problem is that even though they were put on properly they have now completely peeled off and left a lovely sticky goo in their place. I intend to stick them back on using Tarzan Grip or something equally sticky but i need something to get the goo that is currently on the car and decals off before I do it. Also some cleaning tips on how to prep the surface would be greatly appreciated.

Regards

Jas

[Envoke]

Go to bunnings or any other hardware store and look for something like "de-solv it" which are specific glue/residue desolvers which are car friendly (this brand being an orange extract) as for prep, clean and dry, so i suppose water and a bit of soap and then give it some time to properly dry.

[aspir3]

Use prepsol to clean it.

I would use double sided take only to hold them on as one day you will need to remove them

[FizyMo]

Ohh Prepsol mate

[Chubb]

Yeah mate prepsol or an orange based cleaner and as Troy said look for a high strength automotive double sided tape.

[Mizta B]

Prepsol is the go, it removes wax and grease and sticky residue
Painters use it prior to applying undercoat or colour to ensure a good bond on a clean surface after preparation

[ofey]

Might I point out that if you have the receipt for that, you can go back to Mitsu to request a warranty replacement. That one will be 1 yr.

Even better if you bought it at point of sale. The warranty of the item stays with the car!!

[jm]

[quote="ofey"]Might I point out that if you have the receipt for that, you can go back to Mitsu to request a warranty replacement. That one will be 1 yr.

Even better if you bought it at point of sale. The warranty of the item stays with the car!![/quote]

Unfortunatley it's been nearly 2 years since I got them and I didn't buy at point of sale so no warranty for me :-(