Lately i've noticed sometimes above about 3000 there is a slight rattle in the engine under accelleration. its not always there, it tends to come and go. also not long ago my check engine light came on, i was gonna have it checked but it turned off after about an hour. but then my cruise control wouldnt work. i disconnected and reconnected the battery and everything was fine again. yesterday i was backing up a steep driveway and it came on again. it was on all day and then turned off again and again cruise control stopped working. this time i've booked it into mitsubishi to have a look wednesday next week but i was wondering if anyone here has any ideas?
2008 ES with just under 35000km on the clock. logbook service every 15000km.
***** ALERT - Nominations for your new ClubCJ Committee can be made here *****
Slight rattle in engine and CEL going on and off
Moderators: Moderators, Senior Moderators
Yea sounds like an electrical issue. No expert but I don't know. One of the reasons why its recommended that you install a fuse with any electrical modding I suppose.
I had a rattle on the highways but this was mainly from the dash - my lazy loose wiring for my LEDs which I have fixed up now
I had a rattle on the highways but this was mainly from the dash - my lazy loose wiring for my LEDs which I have fixed up now
2010 RenaultSport Megane RS250 Cup Trophee (Xenons+Leather+Front Parkers)
Instead of clutching at straws you need to read the DTC from the ECU to find out why the CEL is coming on, there's no point just guessing out of thin air what it could be. Plus if you get a CEL dont just disconnect and reconnect the battery again, it's obviously coming on for a reason to try tell you the car is rooted and needs checking before you end up potentially damaging your motor.
If you have a cheap OBD-II cable then the person to speak to would be Adrian. He has one of those cheap leads so would know the program it uses. Otherwise take it to your dealer to read the error code out with the MUT-III.
If you have a cheap OBD-II cable then the person to speak to would be Adrian. He has one of those cheap leads so would know the program it uses. Otherwise take it to your dealer to read the error code out with the MUT-III.
Who is online
Users browsing this forum: No registered users and 45 guests