What did you do on your car today?

[Alex.K]

i got led tail lamps and UR braces from ofey and installed them

i broke the tail lamp a bit though =(

[Blakey]

so did i but i bought another set with another member to get mine replaced, we just so happened to break the opposite side to each other. lol

i broke mine trying to get them out again to put the resistors in.

[Alex.K]

Yeah I broke mine thinking it's not a good fit. i should do it right.
but it was already in properly

[JaCe]

I got my car washed and then this arvo a bird (or more?) did an epic poop on it. Not just on the windshield but you can actually see the bird's flight path based on where the poop landed- front bumper, bonnet, A pillar, roof (multiple times) and the wing.

[PYLee]

blessings from above

[bye2u]

i once had bird crap UNDER my wing.. wtf how did that happen lol

[lukeaday]

I got wheels tyres and springs fitted yesterday!!

[Sickbunny]

i fitted my Ultra Racing stickers.. made the car so much stiffer.

well that and the Front Strut brace, Front Lower, and all the rear under car ones besides the sway bar.

i need some sway bars next

[ofey]

I stripped my RA front bumper bar for lukeaday to repaint.

[JaCe]

I'm trying to figure out how to get night mode on my GReddy Informeter Touch. I can see settings for it but it doesn't seem to go dim at night... no light sensor :S

[Red EVOX]

I just spent 6 hours cleaning and detailing my evo..... Its now all ready for the wedding that it is in tomorrow but It'll probably bloody rain now.

[ofey]

I'm trying to figure out how to get night mode on my GReddy Informeter Touch. I can see settings for it but it doesn't seem to go dim at night... no light sensor :S

Could it be that you have to tie a cable between the Touch and your headlamps? So when headlamps come on => night => time to dim?

[JaCe]

I'm trying to figure out how to get night mode on my GReddy Informeter Touch. I can see settings for it but it doesn't seem to go dim at night... no light sensor :S

Could it be that you have to tie a cable between the Touch and your headlamps? So when headlamps come on => night => time to dim?

Found a thread on evolutionm (US forums) and they were reporting same issue. Apparently it's meant to rely on time signal through OBDII (can it even get the time this way?!) to detect whether to have brightness up or not... but yes I thought the cable to headlights switch or a light sensor would've been the way it worked (since my old Apexi RSM had this). I'll keep Googling and when I can, I"ll ask my Japanese friend to help me read the manual (it's all in colour.. but in Japanese!)

[SIR-VRX]

New Fender Brace

Massive bitch to install and I doubt it gives a noticeable difference but meh



Only got this one side installed, will be making a DIY when I do the other side as it is quite a task for those who are inexperienced.

[tadz0rz]

Wraped part of my interior in neffyyyy!!!!



Couldnt get enough light on the middle silver trim but this gives you an idea!!!