***** ALERT - Nominations for your new ClubCJ Committee can be made here *****

RA Gearbox

Servicing, Oil Changes, Fluids & Much More.

Moderators: Moderators, Senior Moderators

User avatar
Beeble
Lancer Ralliart
Lancer Ralliart
Posts: 609
Joined: Thu Jan 27, 2011 11:20 pm
Location: Melbourne, Australia
Contact:

Postby Beeble » Wed Feb 06, 2013 9:32 pm

agree
push hard for a refurbished or replacement transmission
they have zero grounds to deny your claim by the sounds of it.
hopefully you reported it at 40,000km when it first started happening. I would make a point of getting every correspondence in writing from now on. otherwise you will get jerked around.

stick to your guns, keep bugging the service manager.
****************************
Modding or Tuning questions for your Lancer, RA or EVO? drop me a line!
http://BeebleTune.com

User avatar
BZC-45S
Lancer VRX/GTS
Lancer VRX/GTS
Posts: 388
Joined: Mon Feb 20, 2012 10:23 pm
Location: Sydney, AU

Postby BZC-45S » Thu Feb 07, 2013 12:27 am

Good luck, hope the situation falls in your favour.

As much as there are complaints over the SST gearbox online, I have not yet heard of one instance in Australia where someone had been refused warranty by Mitsu Aus for the gearbox. For the most part if you're persistent they'll eventually come around and replace your 'box under warranty.

User avatar
Beeble
Lancer Ralliart
Lancer Ralliart
Posts: 609
Joined: Thu Jan 27, 2011 11:20 pm
Location: Melbourne, Australia
Contact:

Postby Beeble » Thu Feb 07, 2013 11:15 am

true.
it must scare them when customers rock up with a sheet full of codes, and the relevant service manual pages.
Have armed a few people now - they tend to get stuff fixed up pronto :)
****************************

Modding or Tuning questions for your Lancer, RA or EVO? drop me a line!

http://BeebleTune.com

User avatar
talktomrgibson
Lancer Newbie
Lancer Newbie
Posts: 51
Joined: Sun Sep 12, 2010 7:31 pm
Location: Brisbane Australia

Postby talktomrgibson » Fri Feb 08, 2013 9:50 pm

UPDATE:

i got the car back from the service centre today, they have said that they did a drive in it yesterday to collect some data and have sent it to Adelaide (apparently their system is e-mail only and no phones any more....). They expect to hear back next week and have told me that they are aiming at replacing the clutch plates and the mechatronics (the things that decide how much power goes to the gears!?)

i'll keep you updated which how i go, they paperwork says that they sent of the data and that its a *** warranty job *** so that looks good.

basically just made small talk with the service guy about formula 1 (mutual interest haha) then told him i dont care what they do to fix it, but it needs to BE fixed, which is agreed with.

i also ordered a OBD2 USB plug from ebay for like 11 bucks so we will see if that comes in handy :P

will update when i know more.

User avatar
talktomrgibson
Lancer Newbie
Lancer Newbie
Posts: 51
Joined: Sun Sep 12, 2010 7:31 pm
Location: Brisbane Australia

Postby talktomrgibson » Fri Apr 26, 2013 10:28 am

ok another update, they have replaced the Mechatronics unit and the clutch plates and its driving like new again (i think the main issue was the mech unit however they did want to do the clutches and its gone from a 7/10 improvement to 10/10).

overall i'm realy happy with how the dealer handled it and they have looked after me very well (thanks Norris Mitsubishi). I thought they were blowing smoke up my A$$ but it seems that they were being genuine, sorry so many give dealers on the whole a bad rap.

User avatar
rokpapaziz
Lancer Legend
Lancer Legend
Posts: 1344
Joined: Sat Aug 13, 2011 12:18 am
Location: Brisbane

Postby rokpapaziz » Fri Apr 26, 2013 10:36 am

This is great news!

It's not a bad idea to get new clutch packs. Saves having to pull to box apart again.

Sounds like they looked after you well. Nice to know there's some good Mitsubishi dealerships around Brisbane.

When mine got replaced I fully felt like I was taking advantage of them!!

User avatar
Mitsi
Lancer VRX/GTS
Lancer VRX/GTS
Posts: 458
Joined: Wed Sep 22, 2010 12:16 pm
Location: Brisbane, Australia

Postby Mitsi » Fri Apr 26, 2013 10:48 am

Will keep this thread in mind - about to his 30k in our RA :s
2010 Lancer Ralliart <3

User avatar
el3ment
Lancer Legend
Lancer Legend
Posts: 1050
Joined: Thu Nov 18, 2010 8:01 am

Postby el3ment » Fri Apr 26, 2013 1:19 pm

That's awesome news dude... And yeah, the OBD2 is very handy. :) Got one myself :)
AK 3" Single tip exhaust | 18x9 CST Zero 1 Hyper wheels |BC-BR Coilovers | UR UICP | Synapse DV | 3-pod A-Pillar | Adj. rear camber & toe arms | AK Aluminium undertray

Image

User avatar
bunnishiwa
Lancer Legend
Lancer Legend
Posts: 1284
Joined: Thu Dec 24, 2009 4:22 pm
Location: Rye, Melbourne

Postby bunnishiwa » Fri Apr 26, 2013 1:51 pm

Excellent news Nic

Almost a brand new car all over again :D
- Self tuned - work in progress - tune revision #16_03
- GS 3 port controlled wooooot :)
- Lowered on Kings
- Black Evo X FMIC/ Evo IX BOV/ Depo HFC/ UR UICP
- Awesome self installed Alpine/JL Audio sound system
- Whiteline Rear Swaybar



Noli Timere Messorem

User avatar
talktomrgibson
Lancer Newbie
Lancer Newbie
Posts: 51
Joined: Sun Sep 12, 2010 7:31 pm
Location: Brisbane Australia

Postby talktomrgibson » Fri Apr 26, 2013 2:49 pm

bunnishiwa wrote:Almost a brand new car all over again :D


my thoughts exactly! haha drives so smoothly!!!


Return to “Maintenance”

Who is online

Users browsing this forum: No registered users and 7 guests