Page 1 of 1
Ralliart parts.
Posted: Sun May 02, 2021 3:43 pm
by awood
A bloke is parting out his crashed Ralliart up here and I've managed to get the strut tower brace and snorkel for 100 beer tickets. Hopefully get them tomorrow if the public holiday allows.
Is there anything else I should be looking at to get?
I'd love the bonnet but it's munted from the front end crash.
I'll have a look over it tomorrow for any nice shiny aftermarket bits.
Re: Ralliart parts.
Posted: Sun May 02, 2021 5:54 pm
by lancerdarryl
Rear spoiler it's the same as a VRX but it is a little taller than the base model one.
Re: Ralliart parts.
Posted: Mon May 03, 2021 9:17 am
by bumblebee
The front brake calipers are a nice upgrade and direct bolt up for the NA's
Will need RA rotor and pads, they are not too bad $$ wise
Depending on what interior you have there is a few bits around the Radio etc you could grab
If it has a dash mat or rear shelf mat , those will fit the NA
Re: Ralliart parts.
Posted: Mon May 03, 2021 10:00 am
by awood
Thanks mates , I'll look at those parts.
Re: Ralliart parts.
Posted: Mon May 03, 2021 9:15 pm
by Mars1811
Get the gear knob if you've both got auto/manual, those are expensive online.
Re: Ralliart parts.
Posted: Tue May 04, 2021 6:20 pm
by awood
Well good news and bad , got the brace for fifty bucks but snorkel was absent . Must have been lost in the prang.
Interior bits were well and truly neglected and not worth salvaging , even the wheel was completely ruined.
Mars , the knob was there but is a different beast to my CVT trans'.
I'll fit the brace on the weekend and add some pic's.