Page 1 of 1
evo x and lancer driveshaft the same ?
Posted: Mon Feb 02, 2015 8:33 pm
by denzza
Hey guys,
Does anyone know if the evo x driveshaft will fit into the lancer hub ? or are they different dimensions and the splines.
Thanks guys
Posted: Tue Feb 03, 2015 3:36 am
by LiX
They are different length for sure. Hub bearings could be the same.
Posted: Tue Feb 03, 2015 8:00 pm
by denzza
LiX wrote:They are different length for sure. Hub bearings could be the same.
Length isnt my worry, my worry is the X driveshaft going in my hub....
Do i have to change hubs or not.. Not sure if anyone would know
Posted: Tue Feb 03, 2015 9:29 pm
by Speedie
Spline is the same on RA and Evo. Can't say for certain about the Lancer.
Posted: Wed Feb 04, 2015 5:54 am
by LiX
denzza wrote:[quote:f1b7c9afaa=LiX]They are different length for sure. Hub bearings could be the same.[/quote:f1b7c9afaa] Length isnt my worry, my worry is the X driveshaft going in my hub.... Do i have to change hubs or not.. Not sure if anyone would know
Why you are asking this?
Posted: Wed Feb 04, 2015 8:51 pm
by denzza
LiX wrote:[quote:76a5c8c402=denzza][quote:f1b7c9afaa=LiX]They are different length for sure. Hub bearings could be the same.[/quote:f1b7c9afaa] Length isnt my worry, my worry is the X driveshaft going in my hub.... Do i have to change hubs or not.. Not sure if anyone would know[/quote:76a5c8c402] Why you are asking this?
PROJECT :p
Posted: Fri Feb 06, 2015 2:31 am
by LiX
that's not a sufficient answer, what are you trying to do?