Denzza's Lancer RX 2.0 4B11T swap. **2015 UPDATE**

Speedie · Postby **Speedie** » Mon May 04, 2015 1:51 pm

In though the outer sides back to the engine through the middle

denzza · Postby **denzza** » Mon May 04, 2015 3:56 pm

We talking about my sandwhich plate or rokpapaziz's?

Speedie · Postby **Speedie** » Mon May 04, 2015 11:31 pm

How an oil filter works. Do you have flow through yours as the inlet and outlet ports are blocked?

denzza · Postby **denzza** » Tue May 05, 2015 8:11 am

Sorry haha

Again, we talking about my sandwhich plate or rokpapaziz's?

Speedie · Postby **Speedie** » Tue May 05, 2015 12:29 pm

Yours that time, as Marcus is using his for the oil cooler so he will have flow.

denzza · Postby **denzza** » Tue May 05, 2015 1:37 pm

So mine is not connected right or marcus has to watch out how he connects his ?

Speedie · Postby **Speedie** » Tue May 05, 2015 7:31 pm

I don't believe yours is right Denis. Most sandwich plates have an outlet (which on your engine is engine side) and an inlet (radiator side) and they aren't connected inside the plate.

denzza · Postby **denzza** » Tue May 05, 2015 8:54 pm

Hrmm i see. This might explain why im getting slightly higher oil temps ?

But again, it shouldnt matter for my case. Its a sensor, and oil is just passing it right ?

Speedie · Postby **Speedie** » Tue May 05, 2015 9:19 pm

if yours looks like this then your fine

if its like this then your starving the engine of oil

denzza · Postby **denzza** » Wed May 06, 2015 8:27 pm

oh good haha yeah mines the first one . You had me worried there for a little bit.

Thanks a good example for people wanting to install sandwhich plates

denzza · Postby **denzza** » Sat Aug 15, 2015 5:28 pm

UPDATE

Finally got a 3" dump pipe fabricated with a little something :p

1 week later...

Screamer pipe cracked due to vibrations. So it went to get strengthen !!
Also while it was off, i ceramic coated it.

Finally all in!

Then had a dyno day at SPRINGY MOTORS.

Can say i was very surprised with the numbers!
-Full exhaust
-Apexi pod filter
- 13psi. 98 FUEL

------ Also heres a little video of the screamer

---------

https://www.youtube.com/watch?v=hBl8tBoEpFY

Postby **JustinR** » Mon Aug 17, 2015 11:48 am

Cheeky cheeky!

Hows the gearbox holding up with all that power?

denzza · Postby **denzza** » Mon Dec 21, 2015 9:41 pm

JustinR wrote:Cheeky cheeky! Hows the gearbox holding up with all that power?

Yeah Gearbox is surprisingly still good haha

Been off the road for abit now, More MODS :p

Postby **JustinR** » Tue Dec 22, 2015 7:41 am

Care on sharing?

Postby **aspir3** » Tue Dec 22, 2015 10:46 am

Your car is a very interesting build. Lots of information for members to learn here

Denzza's Lancer RX 2.0 4B11T swap. 2015 UPDATE

Who is online