ClubCJ - The CJ Lancer Club

Hello,

I have got a small duck bill spoiler from the factory. However, I would like to know how to remove it. This is a picture from a person that has the same factory duck bill spoiler: https://www.evolutionm.net/forums/attac ... -photo.jpg

If your talking of the small lip on the rear of the boot below the RA wing they are usually held on with double sided tape.
Pop the boot
Lift the boot up
There is about 6 or so small round black tabs
Pop those off and remove the grey liner from the boot lid
Double check there is no bolt holes coming up from under the boot lid

Look thru this

http://imgur.com/a/q02yZWd

It shows the boot lid cover removed

If there is no bolt holes, I'm pretty sure it's a safe bet it's double sided tape like the ones I have seen

There are 3 screws holding them down plus double sided tape. You are best and cheapest to buy a new boot and just paint it rather then trying to fix the holes properly