Door Latch Cover

[Lancer1993]

So decided to get covers for the door latch, just a tiny 'mod' to dress them up but they don't fit. I've notified the seller (assume I chose the right ones) but not worth sending back as it's only a few dollars.

Below is the eBay listing, anyone else tried them?

http://www.ebay.com.au/itm/231425470354 ... EBIDX%3AIT

[CJsportback]

It's a shame they don't fit, very simple little change but actually looks really nice.

[Lancer1993]

I'll let you know if the seller responds.

[lancerdarryl]

The ones I have are from a different seller (Chinese) and are the same.

[Lancer1993]

I was told to warm them up, with some hot water or a heat gun, not sure if this will help?

[Viking]

Heating them with hot water (depending on the thickness of the plastic, the water might need to be almost boiling) and then stretching them should do the trick. A heat gun might be too hot if you're not careful.

[Lancer1993]

Not confident either will work, needs to be a couple of mm wider if you look at the photo I took. Wish they were rubber and could be stretched.

BTW I didn't get a chance to try it today, hopefully tomorrow.