My Daily

[SAM-24A]

@ Haza92

The extender pipe "sleeper" correctly refereed to is commonly known as a "02 SENSOR CEL ELIMINATOR" (or words similar)
This bent pipe essentially removes the 02 Sensor from the path of Exhaust Flow & houses the 02 Sensor in a pocket of Clean Exhaust with the pipe itself. (simple really).








These can be found/purchased from most Performance Exhaust Shops.
Goggle: "02 SENSOR CEL ELIMINATOR" for pics & suppliers.

I know this works, because it has for everyone that used one

[sleeper]

which is to me is a waste of money Sam, as putting in a 2 dollar bung and duct taping the sensor to the brake lines/chassis achieves exactly the same result,.

both methods remove the sensor from the over rich exhaust environment, so therefore no CEL.

the problem with having 1 CEL even though u know what it is Harley, is that if u get a real bad CEL at the same time it wont show up on your info screen

[Haza92]

Thanks lads, yeah the CEL has been giving me the S@#TS since I put the cat on. Either way at least I know now there are a few alternatives to sorting it out. thanks heaps

[Haza92]

which is to me is a waste of money Sam, as putting in a 2 dollar bung and duct taping the sensor to the brake lines/chassis achieves exactly the same result,. both methods remove the sensor from the over rich exhaust environment, so therefore no CEL. the problem with having 1 CEL even though u know what it is Harley, is that if u get a real bad CEL at the same time it wont show up on your info screen

Completely agree there. Is the Hole sizing M18 do you know?

[sleeper]

nope, dunno sam might

[Haza92]

Asking because the apparent universal sizing is m18. Just wanted to clarify

[sleeper]

sam is the thread pitch guy

[SAM-24A]

Haza92 asked:

Is the Hole sizing M18 do you know?

"Correct"
M18 x 1.5mm Thread pitch. (International Standard for all 02 Sensor's)

This thread is also a common Spark Plug thread size.

[Haza92]

Awesome cheers for that